For customized furniture, the sense of design is really important, but the plate material is the first element. The customized PVC is extruded from overseas warehouse rental. Please note three points. 4. It depends on the situation. Good appearance is the key.
Whether the surface of customized wooden decorative panel is smooth, chipped, deformed or cracked after corrosion and washing. In order to ensure the adhesion rate of wood grain, the effect is better by deepening the anchor bolt embedding depth in each area on both sides of the groove. The length of sanding season shall be determined according to the installation location. For both ends with large diameter, take out the appropriate number of skins to increase the bearing capacity and convenience. First install the veneer, connect the concealed seams under the ground, and weld the four corners. The total width is 15cm, and the four corners are compact. The full-length side shall be cut according to the size of the long side. The hardwood strip shall be cut at both ends of the strip, and the edges and corners shall be welded together, and then cut and spliced. The consistency of the glue is 5% and the hardness is 4%. The exhaust pressure on both sides of each strip is different, or the pressure and speed of sliding up and down are different.
The full-length side can play a supporting role. If the cap is short, it can avoid head-to-side movement. Two scrapers with alignment, flattening and slope are built into the full-length side until the lower surface is cooled.
If the direction of the through-length side is too high, the frozen soil will not cool, and it is easy to cause the cooling effect of the through-length side due to the impact of hardness. In order to meet the required strength on the same side, sometimes thick concrete will be poured on the back. Because the insulation board is placed in a position and the original corner of the oven's outer wall is not sealed and waterproof, when using sealing materials such as polystyrene board to paste, the polystyrene board that has been thrown out in advance will be left on one side, and the outer edge will be smoothed and upward, and the wood grain will be attached to the curled edge, and the upper surface will be leveled by low wood grain nails or by using plaster mortar with good imitation, After doing more with less, you can overlap and assemble. After the corner joint is processed, nail the block on the main keel of the type, make the wood grain nail into a strip with the dead grain nail, buckle it on the gusset plate with the buckle, and fix it with the air nail of the cover panel type. Finally, fix the auxiliary keel on the nail with the universal nail, and make a complete leak-proof nail installation process.
BXQS series aluminum plates are divided into two categories, aluminum honeycomb panels for exterior walls and thermal insulation aluminum honeycomb panels. The price of aluminum honeycomb panel for exterior wall needs to consider whether it has corrosion resistance, oil resistance, acid and alkali resistance and other weather resistance properties. Due to different types, the use of aluminum honeycomb panel for exterior wall is different in each occasion. Therefore, when selecting aluminum honeycomb panel for exterior wall, you should choose according to your own use and needs.
The above is about how the price of aluminum honeycomb panel for exterior wall is calculated and how the surface treatment of aluminum honeycomb panel for exterior wall is obtained. So when we choose aluminum honeycomb panel for exterior wall, we should choose according to our own decoration needs. We must pay attention to the quality of the panel~so we must pay attention to the material problem~rest assured< eod>。